Dmytro Lesyk joined the Aeronautics Advanced Manufacturing Center (CFAA) of the University of the Basque Country (UPV/EHU) in October 2023 within the ADAGIO Post-doctoral Fellowship Programme under the Marie Sklodowska-Curie grant. His research project is focused on the Laser 3D printing and post-processing of aircraft products: Verifying structural and surface integrity to increase the operating life of heat-resistant superalloy parts. Dr. Dmytro Lesyk is also an Associate Professor at the Laser Systems and Advanced Technologies Department of the National Technical University of Ukraine  »Igor Sikorsky Kyiv Polytechnic Institute » since 2021. He holds a Bachelor’s degree in Mechanical Engineering in 2009 and a Master’s degree majoring in  »Advanced Technology for Materials Processing » in 2011 from the Igor Sikorsky Kyiv Polytechnic Institute. In 2016, he obtained his PhD degree majoring in « Processes of Physic-Technical Treatment » at the home institution, starting a teaching career as well. PhD thesis titled « Enhancing the surface integrity of steel parts by combined laser-ultrasonic treatment ». In 2013-2014, he underwent PhD Fellowship training at the University of the Basque Country under the supervision of Prof. Aitzol Lamikiz within the Erasmus Mundus EWENT Program. Dr. Dmytro Lesyk was awarded the DAAD Research Grant for Doctoral Candidates and Young Academics and Scientists, working at the Otto von Guericke University Magdeburg, Germany in 2018-2019. He also was a Visiting Researcher at the University of Idaho, USA within the Fulbright Research and Development Program in 2022-2023. In 2022-2023, he also recently underwent Post-doctoral Fellowship training at the West Pomeranian University of Technology, Poland within the Ulam NAWA program.